HP 4200n HP LaserJet 4200 and 4300 series printer - User Guide - Page 167
I/O submenu, The that follows lists the settings and possible values. In the Values column - printer manual ip address
UPC - 808736313971
View all HP 4200n manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
ENWW I/O submenu Items on the I/O (input/output) menu affect the communication between the printer and the computer. The contents of the I/O submenu depend on which EIO card is installed. The section that follows lists the settings and possible values. In the Values column, the default value for each setting is the one with an asterisk (*) next to it. Item I/O TIMEOUT PARALLEL INPUT HIGH SPEED ADVANCED FUNCTIONS EIO [X] TCP/IP ENABLE CONFIG METHOD IPX/SPX ENABLE FRAME TYPE APPLETALK ENABLE DLC/LLC ENABLE LINK SPEED Values Explanation 5 to 300 (*15) Select the I/O timeout period in seconds. This setting allows you to adjust timeout for best performance. If data from other ports appear in the middle of your print job, increase the timeout value. There is no value Configure the parallel features. to select. NO Select YES to enable the printer to accept the faster parallel *YES communications that are used for connections with newer computers. OFF Turn the bidirectional parallel communication on or off. The *ON default is set for a bidirectional parallel port (IEEE-1284). The function allows the printer to send status readback messages to the computer. (Turning the parallel advanced functions on might slow language switching.) There is no value to select. The [X] represents the slot in which the optional HP Jetdirect print server is installed, if any. Which of the following submenus appears depends on the type of print server that is installed. There is no value to select. OFF Select whether the TCP/IP protocol stack is enabled or *ON disabled. You can set several TCP/IP parameters. *BootP DHCP MANUAL Select the TCP/IP configuration method. For the MANUAL option, set the values for IP ADDRESS, SUBNET MASK, DEFAULT GATEWAY, SYSLOG SERVER, and IDLE TIMEOUT. There is no value to select. OFF Select whether the IPX/SPX protocol stack (in Novell *ON NetWare networks, for example) is enabled or disabled. *AUTO OFF Select whether the frame type is automatically determined or turned off. There is no value to select. OFF Select whether the Apple EtherTalk protocol stack is *ON enabled or disabled. There is no value to select. OFF Select whether the DLC/LLC protocol stack is enabled or *ON disabled. *AUTO 10T HALF 10T FULL 100TX HALF 100TX FULL Selects the network link speed (10 or 100 Mbps) and the communication mode (full-duplex or half-duplex). Configure Device menu 165