HP Cisco Nexus 5000 Cisco MDS 9000 Family CLI Configuration Guide - Release 4. - Page 1012

Configuring FCIP Chapter 41 Configuring FCIP Send documentation comments to [email protected] : Step 1 Command switch(config-profile)# tcp send-buffer-size 5000 switch(config-profile)# no tcp send-buffer-size 5000 Purpose Configure the advertised buffer size to 5000 KB. The valid range is from 0 to 16384 KB. Reverts the switch to its factory default. The default is 0 KB. Displaying FCIP Profile Configuration Information Use the show fcip profile command to display FCIP profile configuration information. switch# show fcip profile 7 FCIP Profile 7 Internet Address is 47.1.1.2 (interface GigabitEthernet4/7) Listen Port is 3225 TCP parameters SACK is disabled PMTU discovery is enabled, reset timeout is 3600 sec Keep alive is 60 sec Minimum retransmission timeout is 300 ms Maximum number of re-transmissions is 4 Send buffer size is 0 KB Maximum allowed bandwidth is 1000000 kbps Minimum available bandwidth is 15000 kbps Estimated round trip time is 1000 usec Advanced FCIP Interface Configuration This section describes the options you can configure on an FCIP interface to establish connection to a peer and includes the following topics: • Configuring Peers, page 41-18 • Active Connections, page 41-20 • Number of TCP Connections, page 41-20 • Time Stamp Control, page 41-21 • B Port Interoperability Mode, page 41-22 • Quality of Service, page 41-24 To establish a peer connection, you must first create the FCIP interface and enter the config-if submode. To enter the config-if submode, follow these steps: Step 1 Step 2 Command switch# config terminal switch(config)# interface fcip 100 Purpose Enters configuration mode. Creates an FCIP interface (100). Configuring Peers To establish an FCIP link with the peer, you can use one of two options: 41-18 Cisco MDS 9000 Family CLI Configuration Guide OL-18084-01, Cisco MDS NX-OS Release 4.x