HP Cisco Nexus 5000 Cisco MDS 9000 Family CLI Configuration Guide - Release 4. - Page 964

About Port Security Chapter 39 Configuring Port Security Send documentation comments to [email protected] • Login requests from unauthorized Fibre Channel devices (Nx ports) and switches (xE ports) are rejected. • All intrusion attempts are reported to the SAN administrator through system messages. • Configuration distribution uses the CFS infrastructure, and is limited to those switches that are CFS capable. Distribution is disabled by default. • Configuring the port security policy requires the ENTERPRISE_PKG license (see Chapter 3, "Obtaining and Installing Licenses"). This section includes the following topics: • Port Security Enforcement, page 39-2 • About Auto-Learning, page 39-2 • Port Security Activation, page 39-3 Port Security Enforcement To enforce port security, configure the devices and switch port interfaces through which each device or switch is connected, and activate the configuration. • Use the port world wide name (pWWN) or the node world wide name (nWWN) to specify the Nx port connection for each device. • Use the switch world wide name (sWWN) to specify the xE port connection for each switch. Each Nx and xE port can be configured to restrict a single port or a range of ports. Enforcement of port security policies are done on every activation and when the port tries to come up. The port security feature uses two databases to accept and implement configuration changes. • Configuration database-All configuration changes are stored in the configuration database. • Active database-The database currently enforced by the fabric. The port security feature requires all devices connecting to a switch to be part of the port security active database. The software uses this active database to enforce authorization. About Auto-Learning You can instruct the switch to automatically learn (auto-learn) the port security configurations over a specified period. This feature allows any switch in the Cisco MDS 9000 Family to automatically learn about devices and switches that connect to it. Use this feature when you activate the port security feature for the first time as it saves tedious manual configuration for each port. You must configure auto-learning on a per-VSAN basis. If enabled, devices and switches that are allowed to connect to the switch are automatically learned, even if you have not configured any port access. When auto-learning is enabled, learning happens only for the devices or interfaces that were not already logged into the switch. Learned entries on a port are cleaned up after you shut down that port if auto-learning is still enabled. Learning does not override the existing configured port security policies. So, for example, if an interface is configured to allow a specific pWWN, then auto-learning will not add a new entry to allow any other pWWN on that interface. All other pWWNs will be blocked even in auto-learning mode. No entries are learned for a port in the shutdown state. When you activate the port security feature, auto-learning is also automatically enabled. 39-2 Cisco MDS 9000 Family CLI Configuration Guide OL-18084-01, Cisco MDS NX-OS Release 4.x