HP Cisco Nexus 5000 Cisco MDS 9000 Family CLI Configuration Guide - Release 4. - Page 582

Configuring IVR Chapter 23 Configuring Inter-VSAN Routing Send documentation comments to [email protected] After adding the switch to the IVR topology, you then enable IVR and CFS for the IVR application on the new switch (see the"Enabling IVR" section on page 23-9 and the "Distributing the IVR Configuration using CFS" section on page 23-10). Copying the Active IVR Topology You cannot edit the active IVR topology. However, you can edit the manually configured topology. To copy the active IVR topology database to the manually configure topology, use the following command in EXEC mode: switch# ivr copy active-topology user-configured-topology Clearing the Configured IVR Topology Database You can only clear manually created IVR VSAN topology entries from the configured database. To clear the manually configured IVR VSAN topology database, follow these steps: Step 1 Step 2 Command Purpose switch# config t switch(config)# Enters configuration mode. switch(config)# no ivr vsan-topology database Clears the previously created IVR topology. Verifying the IVR Topology You can verify the IVR topology by using the show ivr vsan-topology command. See Example 23-1 to Example 23-3. Example 23-1 Displays the Configured IVR VSAN Topology switch# show ivr vsan-topology AFID SWITCH WWN Active Cfg. VSANS 1 20:00:00:05:30:01:1b:c2 * yes yes 1-2 1 20:02:00:44:22:00:4a:05 yes yes 1-2,6 1 20:02:00:44:22:00:4a:07 yes yes 2-5 Total: 5 entries in active and configured IVR VSAN-Topology Current Status: Inter-VSAN topology is ACTIVE Last activation time: Sat Mar 22 21:46:15 1980 Note The asterisk (*) indicates the local switch. Example 23-2 Displays the Active IVR VSAN Topology switch# show ivr vsan-topology active AFID SWITCH WWN Active Cfg. VSANS 1 20:00:00:05:30:01:1b:c2 * yes yes 1-2 23-22 Cisco MDS 9000 Family CLI Configuration Guide OL-18084-01, Cisco MDS NX-OS Release 4.x