HP Cisco Nexus 5000 Cisco MDS 9000 Family CLI Configuration Guide - Release 4. - Page 665

Chapter 26 Configuring Fibre Channel Routing Services and Protocols FSPF Interface Configuration Send documentation comments to [email protected] Configuring FSPF Link Cost To configure FSPF link cost, follow these steps: Step 1 Step 2 Command switch# config t switch(config)# switch(config)# interface fc1/4 switch(config-if)# Step 3 switch(config-if)# fspf cost 5 vsan 90 Purpose Enters configuration mode. Configures the specified interface, or if already configured, enters configuration mode for the specified interface. Configures the cost for the selected interface in VSAN 90. About Hello Time Intervals You can set the FSPF Hello time interval to specify the interval between the periodic hello messages sent to verify the health of the link. The integer value can range from 1 to 65,535 seconds. Note This value must be the same in the ports at both ends of the ISL. Configuring Hello Time Intervals To configure the FSPF Hello time interval, follow these steps: Step 1 Step 2 Step 3 Command Purpose switch# config t switch(config)# Enters configuration mode. switch(config)# interface fc1/4 switch(config-if)# Configures the specified interface, or if already configured, enters configuration mode for the specified interface. switch(config-if)# fspf hello-interval 15 vsan 175 Specifies the hello message interval (15 switch(config-if)# seconds) to verify the health of the link in VSAN 175. The default is 20 seconds. About Dead Time Intervals You can set the FSPF dead time interval to specify the maximum interval for which a hello message must be received before the neighbor is considered lost and removed from the database. The integer value can range from 1 to 65,535 seconds. Note This value must be the same in the ports at both ends of the ISL. OL-18084-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family CLI Configuration Guide 26-7