HP Cisco Nexus 5000 Cisco MDS 9000 Family CLI Configuration Guide - Release 4. - Page 505

Chapter 19 Scheduling Maintenance Jobs Configuring the Command Scheduler Send documentation comments to [email protected] • Specifying a Schedule, page 19-6 • Verifying the Command Scheduler Execution Status, page 19-9 Enabling the Command Scheduler To use the scheduling feature, you must explicitly enable this feature on the required switches in the fabric. By default, this feature is disabled in all switches in the Cisco MDS 9000 Family. The configuration and verification commands for the command scheduler feature are only available when this feature is enabled on a switch. When you disable this feature, all related configurations are automatically discarded. To enable the command scheduling feature, follow these steps: Step 1 Step 2 Command Purpose switch# config t Enters configuration mode. switch(config)# feature scheduler Enables the command scheduler. switch(config)# no feature scheduler Discards the scheduler configuration and disables the command scheduler (default). To display the command schedule status, use the show scheduler config command. switch# show scheduler config config terminal feature scheduler scheduler logfile size 16 end Configuring Remote User Authentication Prior to Cisco MDS SAN-OS Release 3.0(3), only users local to the switch could perform scheduler configuration. As of Cisco MDS SAN-OS Release 3.0(3), remote users can perform job scheduling using AAA authentication. Note AAA authentication requires the clear text password of the remote user before creating and configuring command scheduler jobs. OL-18084-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family CLI Configuration Guide 19-3