HP Cisco Nexus 5000 Cisco MDS 9000 Family CLI Configuration Guide - Release 4. - Page 216

CFS Regions Chapter 7 Using the CFS Infrastructure Send documentation comments to [email protected] Managing CFS Regions This section describes how to manage a CFS region. A set of commands are used to complete the following tasks: • Creating CFS Regions, page 7-18 • Assigning Applications to CFS Regions, page 7-18 • Moving an Application to a Different CFS Region, page 7-18 • Removing an Application from a Region, page 7-19 • Deleting CFS Regions, page 7-19 Creating CFS Regions To create a CFS region, perform this task: Step 1 Step 2 Command switch# config t switch(config)# switch(config)# cfs region 4 Purpose Enters configuration mode. Creates a region, for example, number 4. Assigning Applications to CFS Regions To assign an application on a switch to a region, perform this task: Step 1 Step 2 Step 3 Command switch# config t switch(config)# switch(config)# cfs region 4 switch(config-cfs-region)# ntp switch(config-cfs-region)# callhome Purpose Enters configuration mode. Creates a region, for example, number 4. Adds application(s). Moving an Application to a Different CFS Region To move an application, for example from Region 1 (originating region) with NTP and Call Home applications to Region 2 (target region), perform this task: Step 1 Step 2 Step 3 Command switch# config t switch(config)# switch(config)# cfs region 2 switch(config-cfs-region)# ntp switch(config-cfs-region)# callhome Purpose Enters configuration mode. Enters the Region 2. Indicates application(s) to be moved into Region 2 that originally belong to Region 1. For example, here, the NTP and Call Home applications are moved to Region 2. Note If you try adding an application to the same region more than once, you see the error message, "Application already present in the same region." 7-18 Cisco MDS 9000 Family CLI Configuration Guide OL-18084-01, Cisco MDS NX-OS Release 4.x