HP Cisco Nexus 5000 Cisco MDS 9000 Family CLI Configuration Guide - Release 4. - Page 728

Configuring FICON Ports Chapter 29 Configuring FICON Send documentation comments to [email protected] To specify the RLIR preferred host for a VSAN, follow these steps: Step 1 Step 2 Command Purpose switch# config t switch(config)# Enters configuration mode. switch(config)# rlir preferred-cond fcid 0x772c00 Specifies FC ID 0x772c00 as the RLIR vsan 5 preferred host in VSAN 5. (FC ID 0x772c00 is used here as an example.) switch(config)# no rlir preferred-cond fcid 0x654321 vsan 2 Removes FC ID 0x772c00 as the RLIR preferred host for VSAN 5. To display the RLIR preferred host configuration, use the show rlir erl command. switch# show rlir erl Established Registration List for VSAN: 5 FC-ID LIRR FORMAT REGISTERED FOR 0x772c00 0x18 conditional receive(*) 0x779600 0x18 conditional receive 0x779700 0x18 conditional receive 0x779800 0x18 conditional receive Total number of entries = 4 (*) - Denotes the preferred host Displaying RLIR Information The show rlir statistics command displays the complete statistics of LIRR, RLIR, and DRLIR frames. It lists the number of frames received, sent, and rejected. Specify the VSAN ID to obtain VSAN statistics for a specific VSAN. If you do not specify the VSAN ID, then the statistics are shown for all active VSANs (see Examples 29-1 and 29-2). Example 29-1 Displays RLIR Statistics for All VSANs switch# show rlir statistics Statistics for VSAN: 1 Number of LIRR received = 0 Number of LIRR ACC sent = 0 Number of LIRR RJT sent = 0 Number of RLIR sent = 0 Number of RLIR ACC received = 0 Number of RLIR RJT received = 0 Number of DRLIR received = 0 Number of DRLIR ACC sent = 0 Number of DRLIR RJT sent = 0 Number of DRLIR sent = 0 Number of DRLIR ACC received = 0 Number of DRLIR RJT received = 0 Statistics for VSAN: 100 Number of LIRR received = 26 29-28 Cisco MDS 9000 Family CLI Configuration Guide OL-18084-01, Cisco MDS NX-OS Release 4.x