HP Cisco Nexus 5000 Cisco MDS 9000 Family CLI Configuration Guide - Release 4. - Page 298

Reloading Modules Chapter 12 Managing Modules Send documentation comments to [email protected] This example shows the output of the dir bootflash: command: root admin admin root root admin admin root admin admin 14502912 14424576 14469632 14490112 12288 14466048 24206675 19084510 19066505 18960567 Jan 13 12:23:52 1980 kickstart_image1 Jan 14 06:47:29 1980 kickstart_image2 Jan 14 01:29:16 1980 kickstart_image3 Jan 08 07:25:50 1980 kickstart_image4 Jan 16 15:49:24 1980 lost+found/ Jan 14 02:40:16 1980 kickstart_image5 Jan 14 02:57:03 1980 m9500-sf1ek.bin Jan 13 12:23:28 1980 system_image1 Jan 14 06:45:16 1980 system_image2 Jan 14 01:25:21 1980 system_image5 Usage for bootflash: filesystem 158516224 bytes total used 102400 bytes free 167255040 bytes available You can also use the attach module command as follows: • To display the standby supervisor module information, although you cannot configure the standby supervisor module using this command. • To display the switching module portion of the Cisco MDS 9200 Series supervisor module which resides in slot 1. Reloading Modules You can reload the entire switch, reset specific modules in the switch, or reload the image on specific modules in the switch. This section includes the following topics: • Reloading a Switch, page 12-6 • Power Cycling Modules, page 12-6 • Reloading Switching Modules, page 12-7 Reloading a Switch To reload the switch, issue the reload command without any options. When you issue this command, you reboot the switch (see Chapter 8, "Software Images"). Note If you need to issue the reload command, be sure to save the running configuration using the copy running-config startup-config command. Power Cycling Modules To power cycle any module, follow these steps: Step 1 Identify the module that needs to be reset. 12-6 Cisco MDS 9000 Family CLI Configuration Guide OL-18084-01, Cisco MDS NX-OS Release 4.x