HP Cisco Nexus 5000 Cisco MDS 9000 Family CLI Configuration Guide - Release 4. - Page 511

Chapter 19 Scheduling Maintenance Jobs Execution Logs Send documentation comments to [email protected] Deleting a Schedule Time To delete the schedule time, follow these steps: Step 1 Step 2 Step 3 Command switch# conf t switch(config)# switch(config)# scheduler schedule name weekendbackupqos switch(config-schedule)# switch(config-schedule)# no time Purpose Enters the configuration mode. Defines a job schedule (weekendbackup) and enters the submode for that schedule. Deletes the schedule time configuration.The schedule will not be run until the time is configured again. Verifying the Command Scheduler Execution Status To verify the command scheduler execution status, use the show scheduler schedule command. switch# show scheduler schedule configureVsan99 Schedule Name : configureVsan99 User Name : admin Schedule Type : Run once on Tue Aug 10 09:48:00 2004 Last Execution Time: Tue Aug 10 09:48:00 2004 Job Name Status addMemVsan99 Success (0) Execution Logs This section describes execution logs for the command scheduler and contains the following sections: • About Execution Logs, page 19-9 • Configuring Execution Logs, page 19-10 • Clearing the Execution Log File Contents, page 19-10 About Execution Logs The command scheduler maintains a log file. While you cannot modify the contents of this file, you can change the file size. This log file is a circular log that contains the output of the job executed. If the output of the job is greater than the log file, then the output stored in this file remains truncated. You can configure the log file size to be a maximum of 1024 KB. The default size of the execution log file is 16 KB. OL-18084-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family CLI Configuration Guide 19-9