HP Cisco Nexus 5000 Cisco MDS 9000 Family CLI Configuration Guide - Release 4. - Page 711

Chapter 29 Configuring FICON FICON Port Numbering Send documentation comments to [email protected] Note FICON port numbers are not changed for ports that are active. You must first disable the interfaces using the shutdown command. Note You can configure port numbers even when no module is installed in the slot. Installed and Uninstalled Ports An installed port refers to a port for which all required hardware is present. A specified port number in a VSAN can be implemented, and yet not installed, if any of the following conditions apply: • The module is not present-For example, if module 1 is not physically present in slot 1 in a Cisco MDS 9509 Director, ports 0 to 31 are considered uninstalled. • The small form-factor pluggable (SFP) port is not present-For example, if a 16-port module is inserted in slot 2 in a Cisco MDS 9509 Director, ports 48 to 63 are considered uninstalled. • For slot 1, ports 0 to 31, or 0 to 15 have been assigned. Only the physical port fc1/5 with port number 4 is in VSAN 2. The rest of the physical ports are not in VSAN 2. The port numbers 0 to 249 are considered implemented for any FICON-enabled VSAN. Therefore, VSAN 2 has port numbers 0 to 249 and one physical port, fc1/4. The corresponding physical ports 0 to 3,and 5 to 249 are not in VSAN 2. When the FICON VSAN port address is displayed, those port numbers with the physical ports not in VSAN 2 are not installed (for example, ports 0 to 3, or 5 to 249). Another scenario is if VSANs 1 through 5 are FICON-enabled, and trunking-enabled interface fc1/1 has VSANs 3 through 10, then port address 0 is uninstalled in VSAN 1 and 2. • The port is part of a PortChannel-For example, if interface fc 1/1 is part of PortChanne1 5, port address 0 is uninstalled in all FICON VSANs. See Table 29-3. FICON Port Numbering Guidelines The following guidelines apply to FICON port numbers: • Supervisor modules do not have port number assignments. • Port numbers do not change based on TE ports. Since TE ports appear in multiple VSANs, chassis-wide unique port numbers should be reserved for TE ports. • Each PortChannel must be explicitly associated with a FICON port number. • When the port number for a physical PortChannel becomes uninstalled, the relevant PortChannel configuration is applied to the physical port. • Each FCIP tunnel must be explicitly associated with a FICON port number. If the port numbers are not assigned for PortChannels or for FCIP tunnels, then the associated ports will not come up. See the "About Port Numbers for FCIP and PortChannel" section on page 29-12. Assigning FICON Port Numbers to Slots You can use the show ficon port-number assign and show ficon first-available port-number commands to determine which port numbers to use. OL-18084-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family CLI Configuration Guide 29-11