HP Cisco Nexus 5000 Cisco MDS 9000 Family CLI Configuration Guide - Release 4. - Page 217

Chapter 7 Using the CFS Infrastructure Default Settings Send documentation comments to [email protected] Removing an Application from a Region Removing an application from a region is the same as moving the application back to the default region or to Region 0, that is, bringing the entire fabric into the scope of distribution for the application. To remove applications from Region 1, perform this task: Step 1 Step 2 Step 3 Command switch# config t switch(config)# switch(config)# cfs region 1 switch(config-cfs-region)# no ntp switch(config-cfs-region)# no callhome Purpose Enters configuration mode. Enters the Region 1. Removes application(s) that belong to Region 1, which you want to move. Deleting CFS Regions Deleting a region is nullifying the region definition. All the applications bound by the region are released back to the default region by deleting that region. To delete a region, for example, a region numbered 4, perform this task: Step 1 Step 2 Command switch# config t switch(config)# switch(config)# no cfs region 4 WARNING: All applications in the region wiil be moved to default region. Are you sure? (y/n) [n] Purpose Enters configuration mode. Deletes the Region 4. Note After Step 2, you see the warning, "All the applications in the region will be moved to the default region." Displaying CFS Regions To display the CFS regions, perform this task: Step 1 Step 2 Step 3 Command switch# config t switch(config)# switch(config)# show cfs region brief switch(config)# show cfs region Purpose Enters configuration mode. Displays brief information about the CFS regions. Displays detailed information about the CFS regions. Default Settings Table 7-1 lists the default settings for CFS configurations. OL-18084-01, Cisco MDS NX-OS Release 4.x Cisco MDS 9000 Family CLI Configuration Guide 7-19