HP StorageWorks 1606 HP StorageWorks FOS 6.3.0b Release Notes (5697-0360, Apri - Page 22
McDATA Open Fabric Mode interopmode 3. M-EOS 9.9 is required to support Frame Reduction
View all HP StorageWorks 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Integrated Routing9 Yes Yes Domain Offset Support Yes No 239 Domain Support (available on Mi10K only) N/A Yes Masterless F_Port Trunking (AG connect to FOS switches only) Yes Yes FC10-6 to FC10-6 ISL Yes Yes RASLog Events on Duplicate WWNs Yes Yes Virtual Fabrics Yes Yes Logical Fabric using LISLs (XISLs in base Fabric) No No Port Fencing Yes Yes Bottleneck Detection Yes Yes *The feature is available, but not tested or supported. 1Requires M-EOS 9.7 or later for redirection between devices attached to FOS switches, M-EOS 9.8 for redirection between devices attached to M-EOS switches, M-EOS 9.9 for use in McDATA Open Fabric Mode. Supported EOS platforms include M4400, M4700, M6140, and Mi10K. 2Allowed only between FOS-based switches. 3DPS is supported outbound from FOS-based switches. M-EOS can provide reciprocal load balancing using Open Trunking. 4SCC policies are supported only in conjunction with L2 Fabric Binding. 5Not supported in FOS 6.0 or later. 6Mode 3 is qualified only with M-EOS switches. 7Not on FCR. 8Supported only locally on the FOS switch. 9All routers (EX_Ports) must reside in a backbone fabric running in interopmode 0 only. Only edge fabrics with devices imported to the backbone fabric or other edge fabrics can operate in interopmode 2 or 3. 10To support Frame Reduction to an M-EOS edge fabric, there must be at least one FOS switch in the edge fabric to configure Frame Redirection zones. 11Only Frame Reduction zones can be configured on FOS platforms and sent to fabrics operating in McDATA Open Fabric Mode (interopmode 3). M-EOS 9.9 is required to support Frame Reduction zones in McDATA Open Fabric Mode. NOTE: FICON Cascaded CUP is qualified on select platforms only. 22