HP StorageWorks 1606 HP StorageWorks FOS 6.3.0b Release Notes (5697-0360, Apri - Page 69
FOS 6.3.0a fixes, lists defects closed in the FOS 6.3.0a firmware release.
View all HP StorageWorks 1606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
FOS 6.3.0a fixes Table 11 lists defects closed in the FOS 6.3.0a firmware release. Table 11 FOS 6.3.0a closed defects Closed defect summary Solution Switch panic occurs due to Out Of Memory condition when manage- Fixed in FOS 6.3.0a ment application issues repeated FCR LUN emulation queries via SMI, Workaround prior to code change: or when polling a switch that had its password changed multiple times. Disable SMI agents. sysshutdown on 8Gb SAN Switch for HP BladeSystem c-Class may cause panic and reboots. Fixed in FOS 6.3.0a Workaround prior to code change: Use the CLI shutdown command. HP StorageWorks Multiprotocol Router Blade heartbeat stops, causing a reboot while traffic is running over FCIP links. This may cause CP Fixed in FOS 6.3.0a failover, disrupting traffic only on the router blade. After changing the domain offset followed by hafailover on CP1 in interopmode 2 on DC SAN Director, DC04 Director or 4/256 Director, Unknown LSR type messages generated by CP0 scroll continuously on console log. Fixed in FOS 6.3.0a Workaround prior to code change: Perform hafailover to other CP. Under heavy traffic on 10-Gb tunnel on HP StorageWorks DC SAN Director Multiprotocol Extension Blade running in compression mode, back-to-back tunnel parameter modification can cause FCIP traffic to halt due to timing issue with internal buffers. This can also happen on 1-GbE ports, but over a longer I/O run than on 10-GbE ports. Fixed in FOS 6.3.0a I/O times out and stops when running across same VE link as other I/O when failover is done on a trunked EX_Port with HP StorageWorks 1606 Extension Switch or Multiprotocol Extension Blade. Fixed in FOS 6.3.0a Zoning fails with Transaction Commit failed. Reason code 2 (26) - Aca was rejected: Remote Switch Busy, Retry in a few seconds error when E_Port to neighboring Mi10k is lost during a zone push operation when in interop mode. Fixed in FOS 6.3.0a I/O traffic with 1606 Extension SAN Switch or Multiprotocol Extension Blade unable to run across edge-to-edge topology when compression Fixed in FOS 6.3.0a and FastWrite are enabled in certain Virtual Fabric configurations. SFP power-supply values are not displayed correctly after doing a nondisruptive firmware upgrade to FOS 6.2.1. Fixed in FOS 6.3.0a Workaround prior to code change: Execute the command again to obtain the correct values. FCIP tunnel may bounce up and down in an impairment network configuration with compression enabled and highly compressible data I/O with either the 1606 Extension SAN Switch or Multiprotocol Extension Blade. Fixed in FOS 6.3.0a HP StorageWorks FOS 6.3.0b Release Notes 69