IBM 8479 User Reference - Page 101
NDIS 4.0 Windows driver messages, Explanation, Action, Message, Description, Error code hex, Start
UPC - 087944653912
View all IBM 8479 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Table 13. NetWare driver messages for the Ethernet controller. Message Please unload all LAN drivers before unloading AFT.NLM. Description Explanation: An attempt was made to unload the AFT.NLM module before unloading the adapter driver. Action: Unload the adapter driver before unloading the AFT module. NDIS 4.0 Windows driver messages This section contains the error messages for the NDIS 4.0 drivers. The explanation and recommended action are included with each message. Table 14. NDIS (Windows NT) driver messages for the Ethernet controller. Error code (hex) Description 0x00 Explanation: The driver could not register the specified interrupt. 0x01 Action: Using the Configuration/Setup Utility program, make sure that a PCI interrupt is assigned to your Ethernet card, and that Ethernet is enabled. Explanation: One of the PCI cards did not get the required resources. 0x02 Action: Using the Configuration/Setup Utility program, make sure that a PCI interrupt is assigned to your Ethernet card, and that Ethernet is enabled. Explanation: Bad node address (multicast address). 0x03 Action: Make sure the locally administered address is valid, if one is specified. The address cannot be a multicast address. Explanation: Failed self-test. 0x0D Action: Make sure a cable is attached to the Ethernet connector. If the problem persists, call for service. Explanation: Could not allocate enough memory for transmit queues. 0x0E Action: 1. From the Windows NT desktop, click Start → Control Panel → Networks → Adapters. 2. Select your IBM Ethernet adapter from the list. 3. Click Properties → Advanced. 4. Lower the resource values that apply to the transmit queue. Explanation: Could not allocate enough memory for receive queue. 0x0F Action: 1. From the Windows NT desktop, click Start → Control Panel → Networks → Adapters. 2. Select your IBM Ethernet adapter from the list. 3. Click Properties → Advanced. 4. Lower the resource values that apply to the receive queue. Explanation: Could not allocate enough memory for other structures. Action: 1. From the Windows NT desktop, click Start → Control Panel →Networks → Adapters. 2. Select your IBM Ethernet adapter from the list. 3. Click Properties → Advanced. 4. Lower the value for the resource named in the message. Chapter 6. Solving problems 87