Konica Minolta bizhub C552 bizhub C452/C552/C552DS/C652/C652DS Copy Operations - Page 78
Post Inserter, Keys on control panel, Position Setting
View all Konica Minolta bizhub C552 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
5.1 Basic Settings Position Setting 5 Configure desired staple or hole-punch positions. Select Auto, and the machine automatically judges the staple or punch positions for the paper relative to the original direction loaded. • A staple or hole-punch position is set along the long side of the paper if the original length is 11-11/16 inch (297 mm) or less. • Staple or hole-punch positions are set along the short side of the paper if the original length is more than 11-11/16 inch (297 mm). • Staple or punching positions are set on the upper or left-side end. • Be sure to load the original so that its top side is placed in the back. • If desired, press [Original Direction], and then select the original direction. 5.1.6 Post Inserter When the Post Inserter PI-505 is installed on the Finisher FS-526, you can manually operate the Finisher FS-526 using the post inserter control panel. Reference - Only the lower tray can be used as the output tray. The upper tray is not available. Keys on control panel 12 3 45 6 7 10 9 8 No. Name 1 Corner staple lamp 2 Center staple & fold lamp 3 [Finishing] key 4 2-hole lamp 5 3-hole lamp 6 [Select punch] key 7 [Start/stop] key 8 4-hole lamp 9 Tri-fold lamp 10 2 position staple lamp bizhub C652/C652DS/C552/C552DS/C452 5-12