Kyocera TASKalfa 180 180/220 Operation Guide Rev-2 - Page 46
Loading Originals in the Document Processor, Originals Supported by the Document Processor
View all Kyocera TASKalfa 180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Preparation before Use Loading Originals in the Document Processor The optional document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are scanned. Originals Supported by the Document Processor The document processor supports the following types of originals. • Sheet originals only • Paper weight One-sided originals: 45 g/m² to 160 g/m² Two-sided originals: 50 g/m² to 120 g/m² • Sizes: A3 to A5R, Folio, 11 × 17" (Ledger) to 5 1/2 × 8 1/2" (Statement) • Number of originals: 50 sheets (50 g/m² to 80 g/m²) (30 sheets for auto selection mode) Originals Not Supported by the Document Processor Do not use the document processor for the following types of originals. • Soft originals such as vinyl sheets • Transparencies such as OHP film • Carbon paper • Originals with very slippery surfaces • Originals with adhesive tape or glue • Wet originals • Originals with correction fluid which is not dried • Irregularly shaped (non-rectangular) originals • Originals with cut-out sections • Crumpled paper • Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam). • Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases before loading. Failure to do so may cause the originals to jam). Part Names of the Document Processor 3 2 124 5 (1) Original table (2) Original insert guides (3) Left cover (4) Original eject table (5) Ejection extension (6) Document processor release grip (7) Ejection tray 76 2-14 OPERATION GUIDE