Olympus D-100 D-100 Instruction Manual - Page 90
If an Operation Does Not Work
View all Olympus D-100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
90 TROUBLESHOOTING If an Operation Does Not Work When the camera does not work properly Cause Remedy See The camera power is off. Open the lens barrier to turn the camera on. P. 30 Batteries are inserted the wrong way. Remove and insert correctly. P. 29 The battery power has run out. Replace the batteries with new ones. P. 29 Battery performance has dropped Warm the batteries by putting them in your P. 29 temporarily due to cold. pocket before retrying operation. The camera turned off automatically. Close the lens barrier and then open it again. P. 30 The camera is connected to a PC. Dew condensation has occurred inside the camera. Camera operation is not possible while the camera is connected to a PC. - Let the camera dry without turning it on. Once it is completely dry, turn it on. - When the flash does not emit light Cause Remedy See The subject is too bright. If you want to use the flash, set the flash mode P. 58 to the Fill-in Flash mode. The Continuous Shooting mode is engaged. The flash cannot be used in the Continuous Shooting mode. - When the monitor is not clearly visible Cause Remedy The monitor brightness is set improperly. Adjust the brightness. You are watching the monitor under Shade the sunlight with your hand, etc. sunlight. See P. 52 -