Onkyo HT-R640 Owner Manual - Page 36
Connecting Onkyo, Components, Connecting the Power Cord of, Another Component - remote codes
View all Onkyo HT-R640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Connecting the AV Receiver-Continued Connecting Onkyo Components Step 1: Make sure that each Onkyo component is connected to the AV receiver with an analog audio cable (connection a in the hookup examples) (see pages 24 to 35). Step 2: Make the connection. Step 3: If you're using an MD, CDR, or HDD component, change the input display (see page 44). With (Remote Interactive), you can use the following special functions: I Auto Power On/Standby When you start playback on a component connected via , if the AV receiver is on Standby, it will automatically turn on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all components connected via will also go on Standby. This function will not work on components connected to an AC OUTLET on the AV receiver. I Direct Change When playback is started on a component connected via , the AV receiver automatically selects that component as the input source. If your DVD player is connected to the AV receiver's multichannel DVD input, you'll need to press the [MULTI CH] button to hear all channels (see page 46), as the Direct Change function only selects the FRONT DVD IN jacks. I Remote Control You can use the AV receiver's remote controller to control your other -capable Onkyo components, pointing the remote controller at the AV receiver's remote control sensor instead of the component. You must enter the appropriate remote control code first (see page 73). Notes: • Use only cables for connections. cables are supplied with Onkyo players (DVD, CD, etc.). • Some components have two jacks. You can con- nect either one to the AV receiver. The other jack is for connecting additional -capable components. • Connect only Onkyo components to jacks. Connecting other manufacturer's components may cause a malfunction. • Some components may not support all functions. Refer to the manuals supplied with your other Onkyo components. REMOTE CONTROL IN L R CD FRONT L R DVD e.g., CD player e.g., DVD player R L ANALOG AUDIO OUT R L ANALOG AUDIO OUT Connecting the Power Cord of Another Component The AV receiver has an AC outlet on its rear panel for connecting the power cord of another AV component. The other component's power switch can then be left in the ON position so that it turns on or off when the AV receiver is set to On or Standby. European and some Asian models North American models Caution: Make sure that the capacity of the component that you connect to the AC OUTLET does not exceed the stated capacity (e.g., 100W). Notes: • Onkyo components with jacks should be con- nected directly to wall outlets, not the AV receiver's AC OUTLET. • The socket type and capacity will depend on the country in which you purchased the AV receiver. 36