Onkyo HT-R640 Owner Manual - Page 73

Controlling Other Components-Continued Remote Control Codes for Onkyo Components Connected via Onkyo components that are connected via are controlled by pointing the remote controller at the AV receiver, not the component. This allows you to control components that are out of view, in a rack, for example. 1 Make sure the Onkyo component is connected with an cable and an analog audio cable (RCA). See page 36 for details. 2 Enter the appropriate remote control code for the [DVD] or [CD] REMOTE MODE button. [DVD] REMOTE MODE button 1612: Onkyo DVD player with [CD/MD/CDR/HDD] REMOTE MODE button 1327: Onkyo CD player with 1808: Onkyo MD recorder with 1322: Onkyo CD recorder with 1993: HDD-compatible component with See the previous page for how to enter remote control codes. 3 Press the [DVD] or [CD] REMOTE MODE button, point the remote controller at the AV receiver, and operate the component. If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control an Onkyo component that's not connected via , use the following remote control codes: [DVD] REMOTE MODE button 0627: Onkyo DVD player without (default) [CD/MD/CDR/HDD] REMOTE MODE button 1817: Onkyo CD player without (default) 0868: Onkyo MD recorder without 1323: Onkyo CD recorder without 1990: HDD-compatible component without Note: If you connect an -capable Onkyo MD recorder, CD recorder, or HDD-compatible component to the TAPE IN/OUT or VIDEO 3 jacks, for remote operation to work properly, you must set the input display to MD, CDR, or HDD (see page 44). Resetting REMOTE MODE Buttons You can reset a REMOTE MODE button to its default remote control code. 1 While holding down the REMOTE REMOTE MODE MODE button that you want to DVD reset, press the [L NIGHT] button for 3 seconds. M D/CDR CD The REMOTE MODE button lights up. HDD TV VCR CABLE SAT L NIGHT 2 REMOTE MODE DVD M D/CDR C D HDD Press the REMOTE MODE button again. The REMOTE MODE button flashes twice, indicating that it's been reset. TV The [DVD] and [CD] REMOTE MODE buttons are preprogrammed VCR with remote control codes for controlCABLE ling Onkyo DVD players and CD playSAT ers respectively. When these buttons are reset, the preprogrammed code is restored. Resetting the Remote Controller You can reset the remote controller to its default settings. 1 AMP RECEIVER L NIGHT While holding down the [RECEIVER] or [AMP] REMOTE MODE button, press the [L NIGHT] button for 3 seconds. The [RECEIVER] or [AMP] button lights up. 2 AMP RECEIVER Press the [RECEIVER] or [AMP] REMOTE MODE button again. The [RECEIVER] or [AMP] button flashes twice, indicating that it's been reset. 73