Onkyo HT-R640 Owner Manual - Page 64
Speaker Level Calibration
View all Onkyo HT-R640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Advanced Setup-Continued Speaker Level Calibration Here you can adjust the level of each speaker with the built-in test tone so that the volume of each speaker is the same at the listening position. Note: The speakers cannot be calibrated while the output of the AV receiver is muted or while a pair of headphones is connected. 1 2 STANDBY/ON REMOTE MODE RECEIVER DVD TAPE/AMP INPUT SELECTOR M D/CDR 1 2 3 C D HDD V1 V2 V3 4 5 6 TV V4 MULTI CH DVD 7 8 9 VCR TAPE TUNER 10 11 +10 0 C D 12 CABLE CLR SAT D TUN --/--- ENT DIMMER SLEEP TV VOL INPUT GUIDE TOP MENU CH DISC ALBUM VOL PREVIOUS MENU MUTING PLAYLIST/CAT ENTER PLAYLIST/CAT RETURN SETUP 2, 3 1, 5 1 AMP RECEIVER Press the [RECEIVER] or [AMP] button followed by the [SETUP] button. The main menu appears onscreen. SETUP 2 Use the Up and Down [ ]/[ ] buttons to select "3. Level Cali- bration," and then press [ENTER]. The Level Calibration menu appears and the pink noise test tone is output by the front left speaker. 3.Level Calibration a.Left : 0dB b.Center : 0dB c.Right : 0dB d.SurrRight : 0dB e.SurrLeft : 0dB f.Subwoofer : 0dB 3 4 5 SETUP Note: Speakers that you set to No or None on the Speaker Configuration page (page 42) cannot be selected. Use the Up and Down [ ]/[ ] buttons to select each speaker, and use the Left and Right [ ]/ [ ] buttons to set the volume. The volume can be adjusted from -12 to +12 dB in 1 dB steps (-15 to +12 dB for the subwoofer). Repeat step 3 until the volume of the test tone from each speaker is the same. Press the [SETUP] button. The setup menu closes. Note: This procedure can also be performed by using the remote controller. First press the [TEST TONE] button to output the test tone. Use the [LEVEL-] and [LEVEL+] buttons to set the volume, and use the [CH SEL] button to select the speakers. 64