Ricoh 2045 Basics Guide - Page 21

Placing Originals C Lower the ADF. Note ❒ The maximum document length is Note 1200 mm (47"). ❒ When setting a bound original, the received image may contain some black areas. To reduce this effect, hold down the original to prevent the bound part from rising. ❒ If you send documents longer than 420 mm (17"), specify the area to be scanned. If you send such documents frequently, select Long Document mode with the User Parameters. If a jam occurs, the 2 document might be damaged be- Bound original page order cause scanning will not stop. See When setting bound originals (books, magazines, etc.), you can select to have either the left page or right page sent first. See p.55 "Book Fax", Facsimile Reference . p.14 "Setting a Scan Area". See p.147 "Changing the User Parameters", Facsimile Reference (switch 14, bit 1). ❒ Documents longer than 800 mm (32") must be sent by memory Note transmission (immediate transmis- ❒ You can select whether the left sion is not possible). page or right page is sent first. See ❒ If your original is bent or folded, p.147 "Changing the User Parame- flatten it before you place it. ters", Facsimile Reference (switch 06, bit 6). ❒ When sending thin originals, place them on the exposure glass. Placing Originals in the Optional Auto Document Feeder (ADF) Use the ADF to scan in a stack of originals in one operation. The ADF can handle both one-sided and two-sided originals. Limitation ❒ Place all the originals to be sent in a single stack. ❒ If a paper jam occurred, press the {Clear/Stop} key, and then slowly remove the original. ❒ You can check information about the sizes and number of originals that can be placed in the ADF. See p.181 "Acceptable Types of Originals", Facsimile Reference . A Adjust the document guide to match the size of the originals. ❒ You cannot place originals in the ADF one page at a time or in sheaves. 13