Ricoh CL7200 Maintenance Manual - Page 101
p.123, Removing Jammed Sta, p.142, Remove Misfeed, R:Finisher, Appears - print wirelessly
UPC - 026649024115
View all Ricoh CL7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Troubleshooting Messages / Second messages Description Solution Hardware Problem Parallel I/F There is a problem with the par- If you use the parallel I/F, replace the allel interface. interface cable that caused the error. Turn the power off, and then on. If the message appears again, contact your sales or service representative. See "Attaching IEEE 1284 Interface Board Type A", Setup Guide. Hardware Problem Printer font Problems with the font file for the Printer module. It is necessary to replace the print module. Hardware Problem Staple Unit There is a misfeed in the finish- Remove misfed paper. Turn the pow- er or a problem with the staple er off, and then on. If the message ap- unit. pears again, contact your sales or service representative. See p.123 "Removing Jammed Staples". See p.142 "When "Remove Misfeed R:Finisher" Appears". Hardware Problem Tray # There is a problem with the pa- Turn the power off, and then on. If the per lift motor of Tray #. message appears again, contact your #: tray number sales or service representative. Hardware Problem Wireless Board An error was detected in the IEEE 802.11b interface unit or the Bluetooth interface unit. Turn the power off, and then on. Remove and re-install the IEEE 802.11b interface unit or the Bluetooth interface unit correctly. If the message appears again, contact your sales or service representative. See "Attaching IEEE 802.11b Interface Unit Type H" or "Attaching Bluetooth Interface Unit Type 3245", Setup Guide. Hardware Problem Wireless Card The IEEE 802.11b interface unit or the Bluetooth interface unit could not be detected when the power was turned on. The IEEE 802.11b interface card or the Bluetooth interface card was removed after the power was turned on. An error was detected in the IEEE 802.11b interface card or the Bluetooth interface card. Turn the power off, and then on. Remove and re-install the IEEE 802.11b interface unit or the Bluetooth interface unit correctly. If the message appears again, contact your sales or service representative. See "Attaching IEEE 802.11b Interface Unit Type H" or "Attaching Bluetooth Interface Unit Type 3245", Setup Guide. Hardware Problem USB There is a problem related to the Universal Serial Bus Connection and Hardware. Turn the power off, and then on. If the message appears again, contact your sales or service representative. 101