Ricoh CL7200 Maintenance Manual - Page 97

Troubleshooting Error & Status Messages on the Control Panel This section explains what the messages that appear on the control panel mean and what to do when a particular message appears. ❖ Messages (in alphabetical order) Messages / Second messages Description Solution Add staples The stapler is out of staples. Job is not stapled. Replace staples. See p.128 "Adding Staples". Add Toner XXX/XXX The printer is out of the indicat- Replace the toner cartridge of the indi- ed toner(s). cated color(s). XXX: Yellow/Magenta/Cyan/Black See p.40 "Replacing the Toner Cartridge". Add Toner: Cyan The printer is out of toner (C). Replace the toner cartridge (C). See p.40 "Replacing the Toner Cartridge". Add Toner: Magenta The printer is out of toner (M). Replace the toner cartridge (M). See p.40 "Replacing the Toner Cartridge"". Add Toner: Yellow The printer is out of toner (Y). Replace the toner cartridge (Y). See p.40 "Replacing the Toner Cartridge". Calibrating... The printer is calibrating the color. Wait a while. Call Service: EC Power Off On / If Error Reoccur Call Service A communication error sent A communication error sent from the from the engine to the control- engine to the controller. ler. Cannot check Signal in Ad hoc An attempt to check the radio signal was made while the communication mode was set to [Ad hoc] in the interface settings. To check the radio signal , select Infrastructure in the communication mode settings. Certificate auto renewal failed Renewal of the certificate auto- Turn the power off, and then on. If the matically has failed. message appears again, contact your sales or service representative. G1307528_1.00 Copyright © 2005 97