Ricoh CL7200 Maintenance Manual - Page 99
p.134, Removing Punch-hole, Chips, Detaching and Reattaching, the Options - problems
UPC - 026649024115
View all Ricoh CL7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
Troubleshooting Messages / Second messages Description Solution Empty Punch Recep- The Punch Chips container is tacle full of punch chips. Empty the punch waste box. See p.134 "Removing Punch-hole Chips". If the message appears the punch waste box is not full, remove the Punch-hole chips on the top of the punch waste box. See p.134 "Removing Punch-hole Chips". Energy Save Mode In Energy Save Mode level 2. No action required. Error: Enter 10 or 26 characters An ID with an invalid number of Enter the correct number of digits for digits was entered for the WEP the WEP key. key. Error: Enter 5 or 13 characters An ID with an invalid number of Enter the correct number of digits for digits was entered for the WEP the WEP key. key. Error: Tray # Form Feed / Or Job Reset Then Power OffOn The printer identified the failure of the indicated paper tray. The job is not printed. #: tray number Apply Form Feed from another tray or cancel the job, and then switch your printer Off, then back On. If the error continues, contact your sales or service representative. Exceeded Max. Pages (Collate) The printer identified a collation Add extra RAM. page overflow error. Install the optional hard disk drive. Exceeded Max. Stored Files The maximum number of stored files has been exceeded during Sample Print of Locked Print. Delete stored files. Exceeded Max. Stored Pages The maximum number of pag- Reduce the number of pages to print. es has been exceeded during Sample Print of Locked Print. Hardware Problem Ethernet The printer identified an Ether- Turn the power off, and then on. If the net error. message appears again, contact your sales or service representative. Hardware Problem Finisher There is a problem with the finisher. Turn the power off, and then on. Remove and re-install the finisher correctly. If the message appears again, contact your sales or service representative. See p.37 "Detaching and Reattaching the Options". 99