Symphonic CWR20V5 Owner's Manual - Page 12

Before you start Functional overview (cont'd) Installing batteries in the remote control Using a remote control Install two "AA" size batteries (supplied), matching their polarity to those indicated inside battery compartment of the remote control. 1 2 3 Note: Incorrect use of batteries can result in hazards such as leakage and bursting. Please follow the instruction below: • Do not mix new and old batteries together. • Do not use different kinds of batteries together. Although they may look similar, different batteries may have different voltages. • Make sure that the plus and minus ends of each battery match the indications in the battery compartment. • Remove batteries from equipment that is not going to be used for a month or more. • When disposing used batteries, please comply with governmental regulations or public rules for environmental protection that apply in your country or area. • Do not recharge, short-circuit, heat, burn or disassemble batteries. The VCR/DVD recorder Switching Keep in mind the following when using the remote control: • Make sure that there is no obstacle between the remote control and the remote sensor of the unit. • Remote operation may become unreliable if strong sunlight or fluorescent light is on the remote sensor of the unit. • Remote control for different devices can interfere with each other. Avoid using remote control for other equipment located close to the unit. • Replace the batteries when you notice a fall-off of the operating range of the remote control. • The maximum operable ranges from the unit are as follows. - Beeline: approx. 23 feet (7m) - Either side of the center: approx. 16 feet (5m) within 30° - Above: approx. 16 feet (5m) within 15° - Below: approx. 10 feet (3m) within 30° Within about 23feet (7m) POWER REW F.FWD STOP/EJECT PLAY RECORD Remote control REC hREV kPAUSE H P OTROIGPINMAELNU/ CSTOP PLABY gFWD ENTER K PLAYMLEINSUT SKIP G 30˚ 30˚ CHANNEL OPEN/CLOSE DUBBING SELECT VCR SELECT STOP PLAY RECORD DVD S-VIDEO VIDEO L- AUDIO- R Because this product is a combination of a VCR and a DVD recorder, you must select first which component you wish to operate with [SELECT]. VCR MODE Press [VCR] on the remote control. (Verify that the VCR indicator is lit.) DVD MODE Press [DVD] on the remote control. (Verify that the DVD indicator is lit.) Notes: • Pressing only [SELECT] on the front panel DOES NOT switch the mode of the remote control.You MUST select the correct mode on the remote control. • You cannot switch to another mode (DVD or VCR) during in the timer-standby mode. • Pressing [REC/OTR] (DVD) or [REC/OTR] (VCR) on the remote control switches immediately its respective mode so that you can start recording directly on the appropriate media. POWER REW F.FWD STOP/EJECT PLAY RECORD SELECT button OPEN/CLOSE CHANNEL DUBBING SELECT STOP PLAY RECORD VCR SELECT DVD S-VIDEO VIDEO L- AUDIO- R POWER OPEN/CLOSE T-SET TIMER PROG. .@/: ABC DEF 1 2 3 GHI JKL MNO CH 4 5 6 PQRS TUV WXYZ VIDEO/TV 7 8 9 DISPLAY SPACE 0 CLEAR SETUP TOP MENU MENU/LIST RETURN ENTER VCR SELECT DVD VCR button DVD button DVD indicator REC/OTR VCR DVD REC/OTR REC SPEED PLAY REC MONITOR SKIP PAUSE SKIP SLOW CM SKIP STOP SEARCH DUBBING ZOOM AUDIO VCR indicator 10