Xerox 3600B User Guide - Page 65
Installing accessories, Precautions when installing accessories, Installing a memory DIMM - duplex module
UPC - 095205742640
View all Xerox 3600B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
10 Installing accessories Your printer is a full-featured laser printer that has been optimized to meet most of your printing needs. Recognizing that each user may have different requirements, however, Xerox makes several accessories available to enhance the printer's capabilities. This chapter includes: • Precautions when installing accessories • Installing a memory DIMM Precautions when installing accessories Disconnect the power cord: Never remove the control board cover while the power is being supplied. To avoid the possibility of an electrical shock, always disconnect the power cord when installing or removing ANY internal or external accessories. Discharge static electricity: The control board and internal accessories (network interface card and memory DIMM) are sensitive to static electricity. Before installing or removing any internal accessories, discharge static electricity from your body by touching something metal, such as the metal back plate on any device plugged into a grounded power source. If you walk round before finishing installation, discharge any static electricity once again. Installing a memory DIMM Your printer has a dual in-line memory module (DIMM) slot. Use this DIMM slot to install additional memory. Phaser 3600/B has 64 MB, and Phaser 3600N or Phaser 3600/DN has 128 MB of memory. The memory can be expanded to 512 MB. For order information for optional memory DIMMs, see page 7.1. 1 Turn the printer power off and unplug all cables from the printer. 2 Remove the duplex-slot cover from the back of the printer. If you installed an optional duplex unit, remove it from the printer. 3 Grasp the control board cover and slide toward you to open it. 1 1 control board cover 4 Completely open the latches on each side of the DIMM slot. 5 Remove the memory DIMM from its antistatic package. Locate the alignment notches on the bottom edge of the DIMM. 1 1 notch 10.1