ZyXEL VES1724-56B2 User Guide - Page 126

Chapter 9 VDSL Setup Click VDSL Setup and VDSL Bonding Setup in the navigation panel to display the screen as shown. Use this screen to view, add, edit, and delete VDSL port bonding groups. Figure 69 VDSL Bonding Setup The following table describes the labels in this screen. Table 46 VDSL Bonding Setup LABEL DESCRIPTION Active Name Group ID Port Select the check box to enable this group. Enter a descriptive name for this group. Select an identifier number for this group from the drop-down list box. Select a pair of ports to be used by this DSL line group. A port can be in up to one bonding group at a time. Template Profile Select Mode 1 and a single template profile to set a total data rate for the entire bonding group. The total data rate is divided equally for each port. Transmission Mode Add Cancel Clear Group ID Name Active Port Protocol Select Mode 2 and select a separate template profile for each individual port in the bonding group to set each port's data rate independently. Select a transmission standard (ATM for ADSL or PTM for VDSL) to use for this group. Click Add to save the new group of DSL lines on which to use port bonding. It then displays in the summary table at the bottom of the screen. Click Cancel to reset the fields to your previous configuration. Click Clear to clear the fields to the factory defaults. This field displays a VDSL bonding group's ID. Click the ID to modify this group's settings. This field displays the name of the group. This field displays whether this group is enabled (Yes) or not (No). This field displays the port numbers in this group. This field displays the transmission mode protocol (PTM or ATM) this group uses. 126 VES1724-56 User's Guide