ZyXEL VES1724-56B2 User Guide - Page 184

Chapter 17 Link Aggregation Table 76 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP (continued) LABEL * DESCRIPTION Settings in this row apply to all ports. Use this row only if you want to make some settings the same for all ports. Use this row first to set the common settings and then make adjustments on a port-by-port basis. LACP Timeout Note: Changes in this row are copied to all the ports as soon as you make them. Timeout is the time interval between the individual port exchanges of LACP packets in order to check that the peer port in the trunk group is still up. If a port does not respond after three tries, then it is deemed to be "down" and is removed from the trunk. Set a short timeout (one second) for busy trunked links to ensure that disabled ports are removed from the trunk group as soon as possible. Apply Cancel Select either 1 second or 30 seconds. Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click Cancel to begin configuring this screen afresh. 17.6 Static Trunking Example This example shows you how to create a static port trunk group for ports 25-26. 1 Make your physical connections - make sure that the ports that you want to belong to the trunk group are connected to the same destination. The following figure shows ports 25-26 on switch A connected to switch B. Figure 110 Trunking Example - Physical Connections B A 184 VES1724-56 User's Guide