ZyXEL VES1724-56B2 User Guide - Page 309

Chapter 34 Differentiated Services Table 142 IP Application > DiffServ > 2-rate 3 Color Marker (continued) LABEL DESCRIPTION green Specify the DSCP value to use for packets with low packet loss priority. yellow Specify the DSCP value to use for packets with medium packet loss priority. red Specify the DSCP value to use for packets with high packet loss priority. Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Cancel Click Cancel to begin configuring this screen afresh. 34.4 DSCP-to-IEEE 802.1p Priority Settings You can configure the DSCP to IEEE 802.1p mapping to allow the Switch to prioritize all traffic based on the incoming DSCP value according to the DiffServ to IEEE 802.1p mapping table. The following table shows the default DSCP-to-IEEE802.1p mapping. Table 143 Default DSCP-IEEE 802.1p Mapping DSCP VALUE 0 - 7 8 - 15 16 - 23 24 - 31 IEEE 802.1p 0 1 2 3 32 - 39 4 40 - 47 5 48 - 55 6 56 - 63 7 34.4.1 Configuring DSCP Settings To change the DSCP-IEEE 802.1p mapping click the DSCP Setting link in the DiffServ screen to display the screen as shown next. Figure 192 IP Application > DiffServ > DSCP Setting The following table describes the labels in this screen. Table 144 IP Application > DiffServ > DSCP Setting LABEL 0 ... 63 DESCRIPTION This is the DSCP classification identification number. To set the IEEE 802.1p priority mapping, select the priority level from the drop-down list box. VES1724-56 User's Guide 309