ZyXEL VES1724-56B2 User Guide - Page 183

Chapter 17 Link Aggregation Table 75 Advanced Application > Link Aggregation > Link Aggregation Setting (continued) LABEL Apply Cancel DESCRIPTION Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click Cancel to begin configuring this screen afresh. 17.5 Link Aggregation Control Protocol Click Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to display the screen shown next. See Section 17.2 on page 180 for more information on dynamic link aggregation. Note: Do not configure this screen unless you want to enable dynamic link aggregation. Figure 109 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP The following table describes the labels in this screen. Table 76 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP LABEL Active System Priority Group ID LACP Active Port DESCRIPTION Select this checkbox to enable Link Aggregation Control Protocol (LACP). LACP system priority is a number between 1 and 65,535. The switch with the lowest system priority (and lowest port number if system priority is the same) becomes the LACP "server". The LACP "server" controls the operation of LACP setup. Enter a number to set the priority of an active port using Link Aggregation Control Protocol (LACP). The smaller the number, the higher the priority level. The field identifies the link aggregation group, that is, one logical link containing multiple ports. Select this option to enable LACP for a trunk. This field displays the port number. VES1724-56 User's Guide 183