ZyXEL VES1724-56B2 User Guide - Page 213

Chapter 23 VLAN Stacking Click Port-based QinQ in the Advanced Application > VLAN Stacking screen to display the screen as shown. Figure 127 VLAN Stacking > Port-based QinQ The following table describes the labels in this screen. Table 92 VLAN Stacking > Port-based QinQ LABEL Port * DESCRIPTION The port number identifies the port you are configuring. Settings in this row apply to all ports. Use this row only if you want to make some settings the same for all ports. Use this row first to set the common settings and then make adjustments on a port-by-port basis. SPVID Copy Ctag Priority Priority Apply Cancel Note: Changes in this row are copied to all the ports as soon as you make them. SPVID is the service provider's VLAN ID (the outer VLAN tag). Enter the service provider ID (from 1 to 4094) for frames received on this port. See Chapter 10 on page 129 for more background information on VLAN ID. Select the checkbox to set the priority in the service provider (outer) VLAN tag to be the same as the priority in the customer (inner) VLAN tag for the frames received on this port. Select a priority level (from 0 to 7). This is the service provider's priority level that adds to the frames received on this port. This field is not applicable if the Copy Ctag Priority checkbox is selected. "0" is the lowest priority level and "7" is the highest. Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click Cancel to begin configuring this screen afresh. VES1724-56 User's Guide 213