Autodesk 05726-091452-9060 User Guide - Page 201
To create a new character template
UPC - 606121590040
View all Autodesk 05726-091452-9060 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 201 highlights
13 Vectorization Before beginning the training, open the Training OCR dialog box and load the existing library or open a new one. To create a new character template 1. Enter a character in Symbol. 2 Select the raster symbol related to the specified character with one of the selection tools. Select by picking. Click on the standalone raster character. Select by frame. Draw a frame around the raster character. Select by polygon. Specify the vertices that encompass the raster character; press ENTER to complete the selection. the raster character; press ENTER to complete the selection. If you make a mistake, then repeat the procedure. 3. Click the Add button. The program will create a topological template of the character and add it in the appropriate place of the template library. The left part of the dialog box displays the contents of the current template library. This box shows the sections of the template library: digits, English capital, English small, special symbols, national capital, and national small. Closed and nonblank sections are marked with "+". If you check the box to the left of the section name, then all templates located in this section will be enabled. Clearing the checkbox cancels the link to all templates of this section. You can open any section by clicking on "+" and set on/off the necessary templates located in this subfolder, setting / removing the checkmark located to the left of the template name. You can set several templates for each character. The example for "a" is shown in the figure below. In this case the character is marked with "+". You can open a set of templates related to this character by clicking on "+". Then you can select a template by clicking on it. After you have chosen a template, its bitmap is shown on the right of the dialog box. 207