Autodesk 05726-091452-9060 User Guide - Page 219

14 Vector Correction Vector auto correction This procedure is intended for automatic correction of automatic and semiautomatic vectorization (tracing) results. It processes such vector objects as lines, arcs, and circles. After applying Auto correction it is also recommended to apply manual vector correction, if needed. The results of Auto correction performance depends on the width of corrected vectors. Autocorrection allows users: · To restore the contact of lines with arcs and circles · To "stick together" vector fragments in entire objects · To delete vector objects if their size is smaller than specified. A line size is defined by its length, a circle size - by diameter, an arc size - by its largest projection onto the X and Y-axis. · To align lines to regular directions (angle 0°, 30°, 45°, 60°, 90°, etc.) if their deviations from the specified values do not exceed the specified value. To tune the Auto correction parameters 1. Choose Vector Correction Options from the rConvert menu.