Behringer DEEPMIND 12 Manual - Page 61
SHAPE, Triangle, Square, Ramp Up, Ramp Down, Smp&Hold Sample and Hold, KEY SYNC, ARP SYNC
View all Behringer DEEPMIND 12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
61 DeepMind 12 User Manual 4. Selected parameters are adjusted using the -/NO and +/YES switches, the rotary knob or the DATA ENTRY fader. The rotary knob has a click which allows very accurate control. The fader allows rapid adjustment across the full range. • SHAPE - This option allows you to select one of the waveform shapes from the following options (shown below with their typical visualization waveforms from the PROG display). Sine - A mathematically-correct sinusoidal waveform. Triangle - A symmetrical triangular waveform. Square - A symmetrical square waveform. Ramp Up - An up-ramping triangular waveform. Ramp Down - An down-ramping triangular waveform. RATIO 4 3 2 1 1/2 3/8 1/3 1/4 3/16 1/6 1/8 3/32 1/12 1/16 3/64 1/24 1/32 3/128 1/48 1/64 DESCRIPTION Four notes Three notes Two notes One note Half note Dotted quarter note Third note (Half note triplets) Quarter note Dotted eighth note Sixth note (Quarter note triplets) Eighth note Dotted sixteenth note Twelfth note (Eighth note triplets) Sixteenth note Dotted thirty-second note Twenty-fourth note (Sixteenth note triplets) Thirty-second note Dotted sixty-fourth note Forty-eighth note (Thirty-second note triplets) Sixty-fourth note Smp&Hold (Sample and Hold) - A random stepped waveform which transitions instantly from step to step. Smp&Glide (Sample and Glide) - A random stepped waveform which glides from step to step. • KEY SYNC - This option allows you to turn Key Synchronisation On or Off. When KEY-SYNC is On, the LFO waveform generation will be reset as you strike a note (keeping in mind the LFO DELAY TIME is also part of the waveform generation). When KEY-SYNC is Off, the LFO will free run. LFO (KEY SYNC OFF) KEY GATE LFO (KEY SYNC ON) LFO KEY SYNC The default LFO SHAPE setting is the Triangle. • RATE - This option is the same as the physical LFO RATE fader on the surface. Any changes to the LFO RATE fader will be reflected here. The LFO RATE range is from 0 to 255, with 0 being 0.05371 Hz and 255 being 65.4 Hz. The default LFO RATE setting is 0. Note: When the ARP-SYNC is ON, the RATE parameter is not shown, but CLOCK-DIVIDE instead. This menu shows values that are based on the time division of the Master BPM RATE as shown below: Note: For a timing diagram please consult the section later in this document. The default KEY-SYNC setting is Off. • ARP SYNC - This option allows you to turn Arpeggiator Synchronisation On and Off. When ARP-SYNC is On, the LFO waveform will synchronize to the Master BPM. When ARP-SYNC is off, the LFO will run at the rate set by the LFO RATE fader parameter. LFO (ARP SYNC OFF) LFO ARP SYNC ARP CLOCK LFO (ARP SYNC ON) The default ARP-SYNC setting is Off.