Bosch WFVC4400UC User Manual - Page 16

7. Hold the lower rubber portion of the washer foot with a 36 mm (1 1/2 in.) wrench, or pair of slip joint pliers, to keep it from turning. (figure above shows the washer leveling foot removed from the washer for clarity). 8. Use the 16 mm (5/8 in.) wrench to turn the locknut counterclockwise. Turn the locknut until it locks in place against the bottom of the washer. The locknut should be tight against the bottom of the washer. Do not over tighten. i Important: Do not allow the washer leveling foot to turn when turning the locknut, or the height of the corner will be changed. 9. Repeat steps 2 through 7 for each washer leveling foot until the washer is level and all four feet press firmly against the floor. The washer should not rock or move when pressing down on each corner. If it does move, repeat the process. i If a washer foot must be raised (shortened), it may be necessary to reduce the weight on the foot so that it can be turned freely. 10. Periodically recheck the leveling status of the washer. Make sure that all four feet remain locked in place. If any rocking or movement of the washer is observed, recheck the leveling and the position of the washer leveling feet. Transporting the Washer Before transporting the washing machine: - Turn off the water. - Disconnect the washing machine from the power outlet. - Remove the supply and drainage hoses. - Install the transport bolt assemblies (see section below). Preparing and inserting the transport bolt assemblies q Remove all four transport bolt hole covers. q Prepare the transport bolt assemblies: Loosen the screw in the sleeve until the end of the screw is level with the end of the sleeve. q Insert and tighten all transport bolt assemblies. Make sure that the tab on the transportation bolt is inserted in the slot on the washing machine back panel. 16