Campbell Scientific CSAT3B CSAT3B Three-Dimensional Sonic Anemometer - Page 17
LoggerNet, PC400, PC200W, Datalogger Programming using SDM or
View all Campbell Scientific CSAT3B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
CSAT3B Three-Dimensional Sonic Anemometer FIGURE 4-7. CPI and power connections to a CR6 datalogger 3. Use LoggerNet, PC400, or PC200W to send a datalogger program to the datalogger. See Section 8.4, Datalogger Programming using SDM or CPI, for more information on datalogger instructions and programming. 4. Verify that measurements are being made by ensuring the green Status light (FIGURE 4-8) on the CSAT3B block is blinking, indicating that measurements are being made and recorded in the datalogger without diagnostic error conditions. FIGURE 4-8. Lit status light on CSAT3B block 7
CSAT3B Three-Dimensional Sonic Anemometer
FIGURE 4-7.
CPI and power connections to a CR6 datalogger
3.
Use
LoggerNet
,
PC400
, or
PC200W
to send a datalogger program to the
datalogger.
See Section 8.4,
Datalogger Programming using SDM or
CPI
, for more information on datalogger instructions and programming.
4.
Verify that measurements are being made by ensuring the green
Status
light (FIGURE 4-8) on the CSAT3B block is blinking, indicating that
measurements are being made and recorded in the datalogger without
diagnostic error conditions.
FIGURE 4-8.
Lit status light on CSAT3B block
7