Casio WK 3500 User Guide - Page 20

Power Supply Settings Tone, rhythm, and other "main keyboard settings" in effect when you turn off the keyboard manually by pressing POWER button or when Auto Power Off turns off power are still in effect the next time you turn power back on. Main Keyboard Settings Tone number, layer, split, split point, drawbar organ tone settings, transpose, tuning, and contrast settings, touch response, reverb, chorus, DSP, equalizer, rhythm number, tempo, keyboard channel, MIDI In Chord Judge on/off, accomp MIDI out on/off, assignable jack setting, accompaniment volume, user area tones (Synthesizer Mode), user area accompaniments, user DSP area, pitch bend range, Auto Harmonize on/off, Auto Harmonize type, Mixer hold, DSP hold, Auto Accompaniment mode, all Mixer parameters, all Synthesizer Mode parameters, Song Memory song numbers, SMF player settings (play mode, manual play part, SMF playback volume) Turning Off the Keyboard • Be sure to press the POWER button to turn off power and make sure that the LCD backlight is off before disconnecting the AC adaptor or doing anything else. • Never disconnect the AC adaptor while the keyboard is turned on or try to turn off power using any other technique besides pressing the POWER button. Doing so can cause the contents of the keyboard's Flash memory to become corrupted. Strange keyboard operation and abnormal startup when power is turned on are symptoms of corrupted Flash memory contents. See "Troubleshooting" on page E-106 for more information. IMPORTANT! • Never press the POWER button while the following message is on the keyboard's display. (message) "Pls Wait" or "Bulk In" Turning off the keyboard while the above message is on the display can cause user data (user tones, song memory data, etc.) currently stored in keyboard memory or on external media to become corrupted. Once corrupted, you may not be able to recall the data again. Memory Contents In addition to the above settings, data stored in the Registration Mode and Song Memory Mode is also retained when keyboard power is turned off. Saving Setups and Memory Contents About Flash memory Your keyboard comes with built-in Flash memory, which can continue to hold data even when electrical power is totally cut off. This means that even after batteries go completely dead, you can attach the AC adaptor, turn on power, and still recall data stored in memory. You can back up keyboard memory contents and other data using the media described below. • SmartMediaTM Card See "Using a SmartMedia Card" on page E-93. • Floppy Diskette (WK-3500 only) See "Using the Floppy Disk Drive (WK-3500 Only)" on page E-94. IMPORTANT! • When running under battery power, be sure to replace batteries as soon as possible after the first signs of low battery power (dim power indicator lamp, dim display characters, etc.) Though the keyboard's Flash memory is non-volatile (which means that data is not lost when power is interrupted), data can be lost if power suddenly fails while data is being written to flash memory*. * While storing or deleting user data, while recording with the synthesizer, while transferring data from a computer, etc. Initializing the Keyboard Use the procedure on page E-80 to initialize the keyboard, which clears all memory data and returns settings to their initial factory defaults. E-18 WK3100_e_10-25.p65 18 04.3.26, 0:10 PM 735A-E-020A