D-Link DSL-504T Product Manual - Page 54

DSL-504T User's Manual Configuring the WAN Connection Bridged Connection for WAN (continued) ATM VC Setting Under the ATM VC Setting heading, do not change the PVC (Pvc0) PVC: index for the initial connection. ATM VC Setting Also under the ATM VC Setting, you see two numbers, the VCI and VPI & VCI: VPI values. Do not change the VPI or VCI value unless you have been told to do so. These numbers are used to define a unique path for your connection. If you have been given specific settings for this to configure, type in the correct values assigned by your ISP. ATM VC Setting Set the Virtual Circuit setting to Enabled in the pull-down menu if Virtual Circuit: it is not already enabled WAN Setting: Click to select the Bridge Mode radio button in the WAN Settings options list. The menu will change to offer a different set of configuration options. Bridge Mode Under Bridge Mode, choose the Connection Type from the Connection Type: pull-down menu. For bridge mode connections the available encapsulation methods are 1483 Bridged IP LLC and 1483 Bridged IP VCMux. ATM: If you have not been instructed to change the ATM settings at the bottom of the menu, leave these at the default settings. If you have been given new settings to configure, select the Service Category and type in the values for PCR and VCI in Kbps. Apply: Click Apply when you have completed the configuration. The new settings must be saved and the Router must be restarted for the settings to go into effect. To Save & Reboot the Router, click on the Tools directory tab and then click the Misc menu button. In the Misc Settings menu, click the Reboot button under Force the DSL-504T to system restart. The Router will save the new settings and restart. Upon restarting the Router will automatically establish the WAN connection D-Link Systems, Inc. 54