Dell PowerEdge C6420 EMC Installation and Service Manual - Page 96
Installing the expansion card riser assembly
![]() |
View all Dell PowerEdge C6420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
Figure 45. Removing the expansion card riser assembly Next steps 1. Install the expansion card riser assembly. Installing the expansion card riser assembly Prerequisites NOTE: You must install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. 1. Follow the safety guidelines listed in Safety instructions.. Steps 1. Place the expansion card assembly into the system board assembly. 2. Align the riser card connector with the connector on the system board, and press the expansion card riser assembly into place. 3. Using the Phillips #2 screwdriver, tighten the screws that secure the expansion card riser assembly. Figure 46. Installing the expansion card riser assembly 96 Installing and removing enclosure components
![](/manual_guide/products/dell-poweredge-c6420-emc-installation-service-manual-276e056/96.png)