Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Configuration Guide 9.6(0 - Page 103
Bulk Configuration Examples, Create a Single-Range, Exclude a Smaller Port Range, Overlap Port Ranges
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
NOTE: When creating an interface range, interfaces appear in the order they were entered and are not sorted. To display all interfaces that have been validated under the interface range context, use the show range in Interface Range mode. To display the running configuration only for interfaces that are part of interface range, use the show configuration command in Interface Range mode. Bulk Configuration Examples The following are examples of using the interface range command for bulk configuration: • Create a Single-Range • Create a Multiple-Range • Exclude a Smaller Port Range • Overlap Port Ranges • Commas Create a Single-Range Creating a Single-Range Bulk Configuration Dell(conf)# interface range tengigabitethernet 0/1 - 5 Dell(conf-if-range-te-0/1-5)# no shutdown Dell(conf-if-range-te-0/1-5)# Create a Multiple-Range Creating a Multiple-Range Prompt Dell(conf)#interface range tengigabitethernet 0/5 - 10 , tengigabitethernet 0/1 , vlan 1 Dell(conf-if-range-te-0/5-10,te-0/1,vl-1)# Exclude a Smaller Port Range If the interface range has multiple port ranges, the smaller port range is excluded from the prompt. Interface Range Prompt Excluding a Smaller Port Range Dell(conf)#interface range tengigabitethernet 0/1 - 2 , tengigab 0/1 - 7 Dell(conf-if-range-te-0/1-7)# Overlap Port Ranges If overlapping port ranges are specified, the port range is extended to the smallest start port number and largest end port number. Interface Range Prompt Including Overlapping Port Ranges Dell(conf)#inte ra tengig 0/1 - 3 , tengig 0/1 - 7 Dell(conf-if-range-te-0/1-7)# Interfaces 103