Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Configuration Guide 9.6(0 - Page 258
Applying an FCoE Map on Fabric-facing FC Ports, Command, Command Mode, tengigabitEthernet, channel
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 258 highlights
Step 1 2 3 Task Command Configure a server-facing Ethernet port or port channel with an FCoE map. interface {tengigabitEthernet slot/port | portchannel num} Apply the FCoE/FC configuration in an FCoE fcoe-map map-name map on the Ethernet port. Repeat this step to apply an FCoE map to more than one port, for example: Dell# interface tengigabitEthernet 0/0 Dell(config-if-te-0/0)# fcoe-map SAN_FABRIC_A Dell# interface port-channel 3 Dell(config-if-te-0/0)# dcb-map SAN_DCB1 Dell(config-if-po-3)# fcoe-map SAN_FABRIC_A Dell# interface fortygigabitEthernet 0/48 Dell(config-if-fo-0/0)# fcoe-map SAN_FABRIC_A Enable the port for FCoE transmission using no shutdown the map settings. Command Mode CONFIGURATION INTERFACE or INTERFACE PORT_CHANNEL INTERFACE Applying an FCoE Map on Fabric-facing FC Ports The Aggregator, with the FC ports, are configured by default to operate in N port mode to connect to an F port on an FC switch in a fabric. You can apply only one FCoE map on an FC port. When you apply an FCoE map on a fabric-facing FC port, the FC port becomes part of the FCoE fabric, whose settings in the FCoE map are configured on the port and exported to downstream server CNA ports. Each Aggregator, with the FC port, is associated with an Ethernet MAC address (FCF MAC address). When you enable a fabric-facing FC port, the FCoE map applied to the port starts sending FIP multicast advertisements using the parameters in the FCoE map over server-facing Ethernet ports. A server sees the FC port, with its applied FCoE map, as an FCF port. Step 1 2 Task Command Configure a fabric-facing FC port. interface fibrechannel slot/ port Apply the FCoE and FC fabric configurations in fabric map-name an FCoE map to the port. Repeat this step to apply an FCoE map to more than one FC port, for example: Dell# interface fi 0/9 Dell(config-if-fc-0/9)# fabric SAN_FABRIC_A Command Mode CONFIGURATION INTERFACE FIBRE_CHANNEL 258 NPIV Proxy Gateway