Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Configuration Guide 9.6(0 - Page 259
Sample Configuration, Command, Command Mode, Important Points to Remember
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 259 highlights
Step 3 Task Enable the port for FC transmission. Command no shutdown Command Mode INTERFACE FIBRE_CHANNEL Important Points to Remember You can apply a DCB or FCoE map to a range of Ethernet or Fibre Channel interfaces by using the interface range command; for example: Dell(config)# interface range tengigabitEthernet 1/12 - 23 , tengigabitEthernet 2/24 - 35 Dell(config)# interface range fibrechannel 0/0 - 3 , fibrechannel 0/8 - 11 Enter the keywords interface range followed by an interface type and port range. A port range must contain spaces before and after the dash. Separate each interface type and port range with a space, comma, and space as shown in the preceding examples. Sample Configuration 1. Configure a DCB map with PFC and ETS settings: Dell(config)# dcb-map SAN_DCB_MAP Dell(config-dcbx-name)# priority-group 0 bandwidth 60 pfc off Dell(config-dcbx-name)# priority-group 1 bandwidth 20 pfc on Dell(config-dcbx-name)# priority-group 2 bandwidth 20 pfc on Dell(config-dcbx-name)# priority-group 4 strict-priority pfc off Dell(conf-dcbx-name)# priority-pgid 0 0 0 1 2 4 4 4 2. Apply the DCB map on a downstream (server-facing) Ethernet port: Dell(config)# interface tengigabitethernet 1/0 Dell(config-if-te-0/0)#dcb-map SAN_DCB_MAP 3. Create the dedicated VLAN to be used for FCoE traffic: Dell(conf)#interface vlan 1002 4. Configure an FCoE map to be applied on downstream (server-facing) Ethernet and upstream (core- facing) FC ports: Dell(config)# fcoe-map SAN_FABRIC_A Dell(config-fcoe-name)# fabric-id 1002 vlan 1002 Dell(config-fcoe-name)# description "SAN_FABRIC_A" Dell(config-fcoe-name)# fc-map 0efc00 NPIV Proxy Gateway 259