Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Configuration Guide 9.6(0 - Page 246
Configuring Virtual Link Trunking VLT Peer 2, Codes: * - Default VLAN, G - GVRP VLANs, P - Primary
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 246 highlights
Dell_VLTpeer1(conf-if-po-110)#vlt-peer-lag port-channel 110 Dell_VLTpeer1(conf-if-po-110)#end Verify that the port channels used in the VLT domain are assigned to the same VLAN. Dell_VLTpeer1# show vlan id 10 Codes: * - Default VLAN, G - GVRP VLANs, P - Primary, C - Community, I Isolated Q: U - Untagged, T - Tagged x - Dot1x untagged, X - Dot1x tagged G - GVRP tagged, M - Vlan-stack, H - Hyperpull tagged NUM Status Description Q Ports 10 Active U Po110(Te 0/5) T Po100(Te 0/6,7) Configuring Virtual Link Trunking (VLT Peer 2) Configure the backup link. Dell_VLTpeer2(conf)#interface ManagementEthernet 0/0 Dell_VLTpeer2(conf-if-ma-0/0)#ip address 10.11.206.35/ Dell_VLTpeer2(conf-if-ma-0/0)#no shutdown Dell_VLTpeer2(conf-if-ma-0/0)#exit Configure the VLT interconnect (VLTi). Dell_VLTpeer2(conf)#interface port-channel 100 Dell_VLTpeer2(conf-if-po-100)#channel-member TenGigE 0/3,4 Dell_VLTpeer2(conf-if-po-100)#no shutdown Dell_VLTpeer2(conf-if-po-100)#exit Enable VLT and create a VLT domain with a backup-link VLT interconnect (VLTi). Dell_VLTpeer2(conf)#vlt domain 999 Dell_VLTpeer2(conf-vlt-domain)#peer-link port-channel 100 Dell_VLTpeer2(conf-vlt-domain)#back-up destination 10.11.206.23 Dell_VLTpeer2(conf-vlt-domain)#exit Configure the port channel to an attached device. Dell_VLTpeer2(conf)#interface port-channel 110 Dell_VLTpeer2(conf-if-po-110)#switchport Dell_VLTpeer2(conf-if-po-110)#channel-member TenGigE 0/8 Dell_VLTpeer2(conf-if-po-110)#no shutdown Dell_VLTpeer2(conf-if-po-110)#vlt-peer-lag port-channel 110 Dell_VLTpeer2(conf-if-po-110)#end Verify that the port channels used in the VLT domain are assigned to the same VLAN. Dell_VLTpeer2# show vlan id 10 Codes: * - Default VLAN, G - GVRP VLANs, P - Primary, C - Community, I Isolated Q: U - Untagged, T - Tagged x - Dot1x untagged, X - Dot1x tagged G - GVRP tagged, M - Vlan-stack, H - Hyperpull tagged 246 PMUX Mode of the IO Aggregator