Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Configuration Guide 9.6(0 - Page 235
You can remove the inactive VLANs that have no member ports using the following command
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 235 highlights
4. Initialize the port-channel with configurations such as admin up, portmode, and switchport. Dell#configure Dell(conf)#int port-channel 128 Dell(conf-if-po-128)#portmode hybrid Dell(conf-if-po-128)#switchport 5. Configure the tagged VLANs 10 through 15 and untagged VLAN 20 on this port-channel. Dell(conf-if-po-128)#vlan tagged 10-15 Dell(conf-if-po-128)# Dell(conf-if-po-128)#vlan untagged 20 6. Show the running configurations on this port-channel. Dell(conf-if-po-128)#show config ! interface Port-channel 128 portmode hybrid switchport vlan tagged 10-15 vlan untagged 20 shutdown Dell(conf-if-po-128)#end Dell# 7. Show the VLAN configurations. Dell#show vlan Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P - Primary, C - Community, I - Isolated O - Openflow Q: U - Untagged, T - Tagged x - Dot1x untagged, X - Dot1x tagged o - OpenFlow untagged, O - OpenFlow tagged G - GVRP tagged, M - Vlan-stack, H - VSN tagged i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged NUM * 1 10 Status Active Active 11 Active 12 Active 13 Active 14 Active 15 Active 20 Active Dell# Description Q Ports U Te 0/3 T Po128(Te 0/4-5) T Te 0/1 T Po128(Te 0/4-5) T Po128(Te 0/4-5) T Te 0/1 T Po128(Te 0/4-5) T Te 0/1 T Po128(Te 0/4-5) T Te 0/1 T Po128(Te 0/4-5) T Te 0/1 U Po128(Te 0/4-5) U Te 0/1 You can remove the inactive VLANs that have no member ports using the following command: Dell#configure Dell(conf)#no interface vlan vlan-id vlan-id - Inactive VLAN with no member ports PMUX Mode of the IO Aggregator 235