Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Configuration Guide 9.6(0 - Page 108
Setting Auto-Negotiation Options, Command, 10GbaseT, module, 10G SFP, optics, 1G SFP optics
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
show interface status Command Example: Dell# show interfaces status Port Description Status Speed Duplex Vlan Te 0/1 Up 10000 Mbit Full 1-4094 Te 0/2 Down Auto Auto 1-1001,1003-4094 Te 0/3 Up 10000 Mbit Full 1-1001,1003-4094 Te 0/4 Down Auto Auto 1-1001,1003-4094 Te 0/5 Up 10000 Mbit Full 1-4094 Te 0/6 Up 10000 Mbit Full 1-4094 Te 0/7 Up 10000 Mbit Full 1-4094 Te 0/8 toB300 Down Auto Auto 1-1001,1003-4094 Fc 0/9 Up 8000 Mbit Full -- Fc 0/10 Up 8000 Mbit Full -- Te 0/11 Down Auto Auto -- Te 0/12 Down Auto Auto -- In the above example, several ports display "Auto" in the speed field, including port 0/1. Now, in the below example, the speed of port 0/1 is set to 100 Mb and then its auto-negotiation is disabled. Setting Port Speed Example Dell#configure Dell(conf)#interface tengig 0/1 Dell(conf-if-te-0/1)#speed 1000 Dell(conf-if-te-0/1)#no negotiation auto Dell(conf-if-te-0/1)#show config ! interface TenGigabitEthernet 0/1 speed 1000 no shutdown Setting Auto-Negotiation Options Auto-Negotiation, Speed, and Duplex Settings on Different Optics: Command Mode 10GbaseT 10G SFP+ 1G SFP optics module optics Copper SFP Comments - 1000baseT speed 100 interfaceconfig mode Supported Not Not supported( supported(Error Error message is message is thrown) (% Error: thrown) (% Speed 100 not Error: supported on this Speed 100 interface, config not ignored Te 0/49) supported on this interface, config ignored Te 0/49) % Error: Speed 100 not supported on this interface, 108 Interfaces