Dell PowerEdge FX2 Dell PowerEdge FN I/O Aggregator Configuration Guide 9.6(0 - Page 213
Te 0/6Dwn Te 0/7Up Te 0/8Up, MTU 1554 bytes
View all Dell PowerEdge FX2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 213 highlights
Dell# Te 0/6(Dwn) Te 0/7(Up) Te 0/8(Up) Example of Viewing Interface Status with UFD Information Dell#show interfaces tengigabitethernet 0/7 TenGigabitEthernet 0/7 is up, line protocol is down (error-disabled[UFD]) Hardware is Force10Eth, address is 00:01:e8:32:7a:47 Current address is 00:01:e8:32:7a:47 Interface index is 280544512 Internet address is not set MTU 1554 bytes, IP MTU 1500 bytes LineSpeed 1000 Mbit, Mode auto Flowcontrol rx off tx off ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interface" counters 00:25:46 Queueing strategy: fifo Input Statistics: 0 packets, 0 bytes 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts 0 runts, 0 giants, 0 throttles 0 CRC, 0 overrun, 0 discarded Output Statistics: 0 packets, 0 bytes, 0 underruns 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts 0 Multicasts, 0 Broadcasts, 0 Unicasts 0 throttles, 0 discarded, 0 collisions Rate info (interval 299 seconds): Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate Time since last interface status change: 00:01:23 Examples of Viewing UFD Output Dell#show running-config uplink-state-group ! uplink-state-group 1 no enable downstream TenGigabitEthernet 0/3 upstream TenGigabitEthernet 0/1 Dell# Dell(conf-uplink-state-group-16)# show configuration ! uplink-state-group 16 no enable description test downstream disable links all downstream TengigabitEthernet 0/4 upstream TengigabitEthernet 0/5 upstream Port-channel 8 Uplink Failure Detection (UFD) 213