Dell PowerEdge R210 II Owner's Manual - Page 72

Figure 3-12. Removing and Installing a Memory Module 1 2 3 1 memory module 3 alignment key 2 memory module socket ejectors (2) 7 Align the memory module's edge connector with the alignment key of the memory module socket, and insert the memory module in the socket. NOTE: The memory module socket has an alignment key that allows you to install the memory module in the socket in only one way. 8 Press down on the memory module with your thumbs to lock the memory module into the socket. When the memory module is properly seated in the socket, the ejectors on the memory module socket align with the ejectors on the other sockets that have memory modules installed. 9 Repeat step 5 through step 8 of this procedure to install the remaining memory modules. See Table 3-1. 10 Replace the cooling shroud. See "Installing the Cooling Shroud" on page 69. 11 Close the system. See "Closing the System" on page 51. 12 Start up the system, press to enter the System Setup program, and check the System Memory setting on the main System Setup screen. 72 Installing System Components