Dell PowerEdge SC1435 Hardware Owner's Manual - Page 20
See Troubleshooting a Hard Drive - not seeing sata b
View all Dell PowerEdge SC1435 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Table 1-6. System Messages (continued) Message Causes Corrective Actions Read fault Requested sector not found The operating system cannot read from the diskette or hard drive, the system could not find a particular sector on the disk, or the requested sector is defective. Replace the diskette. Ensure that the diskette and hard drive cables are properly connected. See "Troubleshooting a USB Device" on page 71, "Troubleshooting an Optical Drive" on page 78, or "Troubleshooting a Hard Drive" on page 78 for the appropriate drive(s) installed in your system. Remote configuration update attempt failed System unable to process Remote Retry Remote Configuration. Configuration request. ROM bad checksum = address Expansion card improperly installed Reseat the expansion cards. Ensure or faulty. that all appropriate cables are securely connected to the expansion cards. If the problem persists, see "Troubleshooting an Expansion Card" on page 80. SATA port n hard disk drive not found SATA cables are not properly seated, See "Troubleshooting a Hard Drive" on or drive missing. page 78. Sector not found Seek error Seek operation failed Faulty diskette or hard drive. See "Troubleshooting a USB Device" on page 71 or "Troubleshooting a Hard Drive" on page 78 for the appropriate drive. Shutdown failure Shutdown test failure. See "Troubleshooting System Memory" on page 76. The amount of system memory has changed Memory has been added or removed If memory has been added or removed, or a memory module may be faulty. this message is informative and can be ignored. If memory has not been added or removed, check the SEL to determine if single-bit or multi-bit errors were detected and replace the faulty memory module. See "Troubleshooting System Memory" on page 76. This system supports only Microprocessor(s) is not supported Install a supported microprocessor or Opteron 2000 series by the system. microprocessor combination. See processors. "Processors" on page 50. Time-of-day clock stopped Faulty battery or faulty chip. See "Troubleshooting the System Battery" on page 74. 20 About Your System