Dell PowerEdge SC1435 Hardware Owner's Manual - Page 43
Installing the Power Supply, Close the system. See Closing the System.
View all Dell PowerEdge SC1435 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Figure 3-6. Removing and Installing a Power Supply 3 2 1 4 5 1 hard-drive power cables (2) 4 POWER2 connector 2 retention screw 5 POWER1 connector 3 power supply Installing the Power Supply NOTICE: On a rack system, you may need to temporarily unlatch and lift the cable management arm. For information about the cable management arm, see the system's Rack Installation Guide. NOTICE: For more information about the power cable retention bracket, see Getting Started With Your System. 1 Lower the power supply into the system and slide the power supply into place against the back panel of the system. See Figure 3-6. 2 Reinstall the screw that secures the power supply to the chassis. 3 Connect the two power supply cables to the POWER1 and POWER2 connectors on the system board. See Figure 3-6. 4 If applicable, route the hard drive power cables through the oval opening in the chassis brace and connect them to the hard drives. 5 Close the system. See "Closing the System." Installing System Components 43